Dogtra arc handsfree5/18/2023 ![]() The handheld transmitter’s antenna should be kept in the open for maximum range. Rangeĭepending on where the handheld transmitter is placed, your body can act as a barrier between the HANDSFREE SQUARE and the transmitter. With normal usage (button held for 12 seconds, 100 times a day), the battery should last 7-10 years. Replace the battery when the LED no longer blinks. The LED on the HANDSFREE SQUARE will blink when the button is pressed. The HANDSFREE SQUARE has been tested and can be used in extreme conditions, between -4 ☏ to 140 ☏. The function (Nick, Constant, or Pager) can be coded for you to operate remotely by pressing the HANDSFREE SQUARE, instead of having to carry the transmitter. The HANDSFREE SQUARE gives you the freedom to multitask and have discreet fingertip control. The HANDSFREE SQUARE should now be coded. The transmitter will continue to rapidly blink until the next step is completed. The LED light on the receiver will blink every 4 seconds when coding is complete. While the green LED is rapidly blinking on the receiver, separate the two devices and press the two side buttons (Nick & Constant) simultaneously on the transmitter.Hold the two red dots together for about 5 seconds until the green LED blinks rapidly on the receiver. With the receiver turned off, place the red dot on the back of the transmitter to the red dot on the receiver.Turn the transmitter on by pressing the on/off button and set the Rheostat Dial to 0.To turn the receiver off, touch the two red dots together momentarily and a red LED light will indicate it is off. To turn the receiver on, place the red dot on the back of the transmitter to the red dot on the receiver, which will show an LED light when turned on. To turn the transmitter off, hold down the same button on the right side of the transmitter until the LCD screen shuts off. To turn the handheld transmitter on, hold down the button on the right side of the transmitter until the LCD screen illuminates. Release the button once the rapidly flashing light on the transmitter and the HANDSFREE SQUARE both show a solid light. Hold down the HANDSFREE SQUARE button.Once you see the rapidly blinking light, release the buttons.On the handheld transmitter, hold down the following buttons to code the desired setting on the HANDSFREE SQUARE.Begin with the transmitter turned off.To change the setting, proceed with the following steps: The default setting for the HANDSFREE SQUARE is Constant stimulation. The LED light on the receiver will blink every 4 seconds when coding is complete.Ĭoding the transmitter and HANDSFREE SQUARE: While the green LED is rapidly blinking on the receiver, press the two side buttons (Nick & Constant) simultaneously on the transmitter.With the receiver turned off, hold the on/off button on the receiver until the LED light begins to rapidly blink green. ![]()
0 Comments
Leave a Reply. |